Skip to content

Updated adventures in 3D printing 1:6 scale action figure heads: the Spymaster and Missy!

Updated adventures in 3D printing 1:6 scale action figure heads: the Spymaster and Missy! published on No Comments on Updated adventures in 3D printing 1:6 scale action figure heads: the Spymaster and Missy!

It’s been a bit since I last posted about my tests in 3D printing 1:6 scale action figure heads. Here’s the latest on the Spymaster and Missy.

The first Missy that I printed, at left, was way too small. She also didn’t have enough cranium. She’d be a good scale for the 10″ Character Options Thirteenth Doctor, though. The second Missy, at right, was the proper size. She’s currently in progress.
As for this dingus, I tried printing him out in cheap white Versatile Plastic [second from left]. Too rough. I went back to Smooth Fine Detail Plastic [as shown in first on left, which is painted, and third from left, which is unpainted]. The first on left is a commission. I guess my versions of the Spymaster have neater hair than most.

Leave a Reply

Your email address will not be published. Required fields are marked *

Primary Sidebar